The instrumentation and procedure is described for the extraction of very small and pure samples from polished mounts and thin sections of minerals, for X-ray analysis and other micro-analytical techniques. It uses a stand-mounted, tunable ultrasonic probe (400 W/15–50 kHz) inclined at 45°C to a microscope stage. The tip of the probe, usually a steel needle, is located on the desired mineral and an appropriate ultrasonic frequency is selected. Very fine powders are produced from grains as small as 0.01–0.005 mm. A distinct advantage of this technique is that, as different minerals powder at different rates and different frequencies, it is possible to separate a single mineral from an intergrowth of two or more minerals.